Siemens SINUMERIK 840D sl Manual De Puesta En Marcha página 52

Menú de canales
5.6 Ejemplo: Ajustes con 1:N
Ejemplo netnames.ini
;******************************************************************
;
;
; This is an example of a netnames.ini for 1:N NCU-switching in
; a configuration of 3 NCU and a PCU50.
;*******************************************************************
[own]
owner = HMI
;***************************
; ChanMenu
;***************************
[chan HMI]
ShowChanMenu = true
;*******************************************************************
;Channel-groups
;Correlation from channel-group to horizontal softkeys
; -> see config.ini of the TCU
;The section [T2M2N] can also be created in the netnames.ini file
;instead of config.ini file. This configuration applies to all TCU,
;which are not configured by their config.ini.
;*******************************************************************
[T2M2N]
SK1 = CH_GRP_1
SK2 = CH_GRP_2
[CH_GRP_1]
Text = 1. NCU
Member1.Target = 192.168.214.241.192.168.214.1.#1
Member1.Text = NCU1%nKanal 1
Member2.Target = 192.168.214.241.192.168.214.1.#2
Member2.Text = NCU1%nKanal 2
[CH_GRP_2]
Text = 2. NCU
Member1.Target = 192.168.214.241.192.168.214.2.#1
Member1.Text = NCU2%nKanal 1
Member2.Target = 192.168.214.241.192.168.214.2.#2
Member2.Text = NCU2%nKanal 2
Nota
Para conmutar un MCP con el software de manejo, no se debe utilizar el bloque de PLC
FB9 (FB9 no debe estar activo). La conmutación de MCP debe realizarse, en caso
necesario, en el programa de usuario del PLC.
46
netnames.ini - EXAMPLE -
Manual de puesta en marcha, 03/2013, 6FC5397-1DP40-3EA1
SINUMERIK Operate (IM9)