Milwaukee HEAVY DUTY M18 FHS20 Manual Original página 15

WARNING!
Failure to replace or repair a damaged chain
can cause serious injury.
WARNING!
The saw chain is sharp. Always wear
protective gloves when performing maintenance to the chain.
Guide Bar Maintenance
When the guide bar shows signs of wear, flip the guide bar from
bottom to top on the saw to distribute the wear for maximum bar
life. The bar should be cleaned every day of use and checked for
wear and damage. Feathering or burring of the bar rails is a normal
process of bar wear. Such faults should be smoothed with a file as
soon as they occur.
Bar Rails
A bar with any of the following faults should be replaced.
• Wear inside the bar rails which permits the chain to lay over
sideways.
• Bent guide bar.
• Cracked or broken rails.
• Spread rails.
Lubricate guide bars with a sprocket at their tip weekly. Using a
grease syringe, lubricate weekly in the lubricating hole. Turn the
guide bar and check that the lubrication holes and bar rails are free
from impurities.
Maintenance schedule
Daily check
Bar lubrication Before each use
Chain tension Before each use and frequently
Chain sharpness Before each use, visual check
For damaged parts Before each use
For loose fasteners Before each use
Guide Bar Before each use
Complete saw After each use
Replacement parts (Bar and chain)
Manufacturer MILWAUKEE OREGONO
Chain 4932 4801 76 90F033XTR
Guide Bar 4932 4801 69 360804
Chain must be fitted with bar from the same manufacturer according
to above combinations.
Exploded view
If needed, an exploded view of the tool can be ordered. Please
state the Article No. as well as the machine type printed on
the label and order the drawing at your local service agents or
directly at: Techtronic Industries GmbH, Max-Eyth-Straße 10,
71364 Winnenden, Germany.
28
SYMBOLS
Please read the instructions carefully before starting
the machine.
CAUTION! WARNING! DANGER!
Remove the battery pack before starting any work on
the appliance.
Never expose tool to rain.
Not use one-handed
Always use pruning saw two-handed
Wear safety shoes with cut protection, grippy sole and
steel toe!
Wear gloves!
Always wear protective clothing and footwear.
Weare a protective helmet.
Wear ear protectors!
Use safety glasses.
Beware of pruning saw kickback and avoid contact
with bar tip
Keep bystanders at least 50ʹ away during use.
Chain Oil Reservoir
Rotate to adjust chain tension
Chain running direction
Accessory - Not included in standard equipment,
available as an accessory.
ENGLISH
Do not dispose of waste batteries, waste electrical and
electronic equipment as unsorted municipal waste.
Waste batteries and waste electrical and electronic
equipment must be collected separately. Waste
batteries, waste accumulators and light sources have
to be removed from equipment. Check with your local
authority or retailer for recycling advice and collection
point. According to local regulations retailers may
have an obligation to take back waste batteries and
Waste electrical and electronic equipment free of
charge. Your contribution to re-use and recycling of
waste batteries and waste electrical and electronic
equipment helps to reduce the demand of raw
materials. Waste batteries, in particular containing
lithium and waste Electrical and electronic equipment
contain valuable, recyclable materials, which can
adversely impact the environment and the human
health, if not disposed of in an environmentally
compatible manner. Delete personal data from waste
equipment, if any.
Guaranteed sound power level 79 dB(A)
v
No-load chain speed
0
V
Voltage
Direct Current
European Conformity Mark
British Conformity Mark
Ukraine Conformity Mark
EurAsian Conformity Mark
ENGLISH
29