Aiwa NSX-4000 Manual De Instrucciones página 18

I;I
B
POWER
SET
BEFORE O PERATION
To turn on the unit --* []
Press the POWER button.
You can also turn the unit on by pressing One of the direct play
buttons.(See page 20.)
After use
Press the POWER button to turn off the power. The display
changesto clock or DEMO mode.
After turning on the unit
The flash windowabove the disc compartment lightsup.
For 4 seconds, the most recently used functionbutton flashes in
green.
No operation may be carried out during this4-second period.
The flash window -- []
The flash window lightsup duringpower on and flashes when the
disc compartment is opened or closed, and when the trays are
rotated.
To turn it off, operate as follows:
1 Turn on the power and press the CD button. (The CD button
lightsin red.)
2 Press the • button while pressingthe CD button.
To turn it back on, repeat the procedure.
• Do not carry out thisoperati_ during recording.
Illumination guide _ []
Whenever one of the functionbuttonsis pressed, the buttonsfor
that operationlight up or flash.
Example:
When connectingthe AC cord,the I I SET buttonflashestoguide
you in settingthe currenttime.
Headphones
Connect headphones to the PHONES jack with a stereo standard
plug (_6.3 mm/V4 inch).
No sound is heard from the speakers while headphones are
plugged in.
After a power Interruption
The currenttime needs to be reset. (See page 22.)
• If power is interruptedfor morethan about24 hours,you willalso
have to reset preset stations and timer playback or recording
settings.
18