Aiwa NSX-4000 Manual De Instrucciones página 62

...___J
"= 0
..Lv
q_
1
TIMER
®/®
REC
2
3
4
SET
DOWN UP
SET
HI<DOWN UPIHH
SET
7
TAPE TUNER/BAND VIDEO/AUX CD
62
SETTING T HETIMER
The unit can be turned on at the specifiedtime every day by the
built-intimer. You can also settimer recordingfrom the radioorthe
connected equipment.
Preparation
• Make sure the clock is set correctly. (See page 22.)
• Note that the timer-on period is factory-set to 60 minutes. This
pedod can be changed during timer setting.
Press the TIMER button to select timer playback
mode or timer recording mode.
Each time it is pressed, _) or R_ is displayed.
F (_Timer playbackmode --_ RE_)cTimer recording mode -1
Cancel •
The IIII SET button lights, and TIMER and one of the source
names flash alternately in the display for 4 seconds. Go to step
2 within these 4 seconds. If TIMER in the display goes out,
press the TIMER button again.
2
3
a
If you proceed to step L_after TIMER in the display goes out,
another operation may star_.
/
Press the II SET button.
The hourinthedisplay flashes.
Press the <_ DOWN or _ UP button to designate
the hour of the timer-on time.
4 Press the II SET button to set the hour.
The hour stops flashing and the minute starts flashing in the
display.
5 Press the 4_ DOWN or =,.D. UP button to designate
the minute of the timer-on time.
6 Press the II SET button to set the minute.
The minutestopsflashing in the display.
TIMER and one of the source names flash alternately in the
displayfor 4 seconds. Go to step 7 within these 4 seconds
to select a source.
Press one of the function buttons to select a
source.
The selected source name and TIMER flash alternately in the
display.
After4 seconds,TIM ER inthe displaygoesoutandtimersetting
is completed.
If you selected the timer recording mode in step 1
Only the TUNER or VIDEO/AUX functioncan be selected.
If you press the TUNER/BAND button
The tuner function is selected,but bands cannnot be selected
in thisstep. Go to step 8, and select a band.
To b continued.