Aiwa NSX-4000 Manual De Instrucciones página 54

AIEDITRECORDING
3
4
CD EDIT/REMAIN
DISC DIRECT PLAY
b
5
DOWN UP
6
REC/REC MUTE
The AI EDIT function lets you record CDs withoutworryingabout
tape lengths and track lengths. When you insert a CD, the unit
automaticallycalculatestrack lengths. If necessary, it rearranges
the order of tracks, so that no track is cut short.
2
3
Insert the tape to be recorded on into the deck and
set the Dolby NR.
See steps 1 and 2 on page 52 "RECORDING FROM A CD".
Press the CD button and load discs onto the trays.
Press the CD EDIT/REMAIN button once.
EDIT lightsand AI flashes in the display.
Each time it _ pressed, the displaychanges.
r A' E D,T '--- RGM EO,T-I
When usingthe remote control,press the EDIT/REMAIN but-
ton.
Select a disc by pressing one of the DISC DIRECT
PLAY buttons.
If only one disc is loaded, skip thisstep.
Press the-,1,,1 DOWN _lr =,,=,.UP button to designate
the tape length.
Enter a length from 10 to 99 minutes.
In a few seconds, the microcomputerdecides which tracksto
record on each side of the tape.
When using the remote control
Press the numeric buttons.
Example:
_) When usinga 46-minute tape, press the 4 and 6 buttons.
(_) When usinga 60-minute tape, press the 6 and 0 buttons.
O Recordingtime
(_ Tape side
A: Front side/B: Back side
(_ Selected tracks
6 Press the • REC/REC MUTE button to start record-
Ing.
The tape is rewoundto the beginningof the frontside, plays
throughthe leader for 10 seconds, and then recordingstarts.
After recordingon the frontside (side A) ends, recordingon the
back side (side B) starts.
When you use the remote control to startrecording,first press
the e/O REC/REC MUTE buttonand then pressthe <- button
within 2 seconds.
To atop recording in the middle of the program
Press the • button.
Recordingand CD play stop simultaneously.
• Recording is inhibited if the erasure prevention tab for either side
of the tape is broken off.
• The AI EDIT function cannot be used with discs containing 31
tracks or more.
54