Aiwa NSX-4000 Manual De Instrucciones página 22

'ql
1
2
3
4
5
L.____jJ
©
O0
SET
DOWN UP
SET
I<I<IDOWN UP IHH
SET
SETTING THECLOCK
When you first connectthe AC cord, the IIIISET buttonflashes to
informyou that the currenttime needs to be set. Set the time as
follows, while the power is stilloff.
1 Press the II SET button.
The hourflashes.
2 Press the ,91<1 DOWN
designate the hour.
or P,P. UP button to
3 Press the II SET button to set the hour.
The hour stopsflashing and the minute startsflashing.
4 Press the ,<,9 DOWN or I_1_ UP button to desig-
nate the minute.
Press the II SET button to set the minute 'and
complete setting.
The minute stops flashing in the display and the clock starts
runningfrom 00 seconds. ,
To setthe time moreaccurately, pressthe
II
SET buttonwhen
anotherclockor a time signal indicatesthat the currenttime is
00 seconds.
Each colonflash in the displayindicatesone second.
To correct the current time .--* []
Press the CLOCK button on the remote control. The clock is
displayed and the II SET button on the main unit flashes for 4
seconds.
Within this period, press the II SET button and continue by
following steps 2 to 5.
To display the current time while the power is on
Press the CLOCK button on the remote control.The currenttime
is displayedfor 4 seconds.
However, the time cannot be displayed, during recording.
To switch to the 24-hour standard
The clock isfactory-set to the 12-hour standard. To switchto the
24-hour standard, pressthe CLOCK buttonon the remote control
and then press the • buttonwithin 4 seconds. Repeat the same
procedureto restore the 12-hourstandard.
After e power interruption
If you switch the display to clock, the clock flashes to remind you
that the current time needs to be reset.
M
(;;_ C:)II
_;;) C:) Q _ II
CLOCK
22