Configuring The Bus System - Aventics CANopen VS CL03 Serie Instrucciones De Servicio

86 AVENTICS | CANopen | R402003660–BAL–001–AE
Commissioning and operation
7.2

Configuring the bus system

The configuration steps laid out in this section are superior to
the settings on the bus coupler which have already been
described (see "Making settings" on page 81) and are a part of
the bus master configuration of the entire system.
The work described here may only be carried out by qualified
electronics personnel and in compliance with the operator's
documentation on configuring the bus master, as well as
applicable technical standards, directives, and safety
regulations.
Before starting configuration, the following steps must have
been carried out and completed:
You have assembled the bus coupler and the valve system
(see "Assembly" on page 74).
You have assembled the bus coupler and valve terminals
(see "Connecting the bus coupler electrically" on page 76).
You have connected the bus coupler (see "Making settings"
on page 81).
Configuration error
An incorrectly configured bus coupler will lead to
malfunctions in the system and may damage the system.
The configuration may only be carried out by qualified
electronics personnel!
Configure the bus system in accordance with your system
requirements, the manufacturer's specifications, and all
valid technical standards, directives, and safety regulations.
Take the operator's documentation on configuring the bus
master into account.