Panasonic MINAS A6 Multi Serie Referencia Técnica página 87

6.1 Validation Report
Comments Helpful comments, e.g. file name of the logic plan
Step: Completion of approval
Item Description
Inspector 1 Inspector Name
Date Date of the examination
Sign Field for the signature of the inspector
Inspector 2 Inspector Name
Date Date of the examination
Sign Field for the signature of the inspector
Step: Fill in the contact details
Item Description
Version Document version
Installation Description of the installation site
Customer Operator of the equipment
Supplier Manufacturer of equipment / equipment
Installer Information on putting the equipment into operation
A telephone and fax number can also be entered in the fields Installation, Customer, Supplier and Installer.
Step: Fill in the description
Item Description
Installer Person who installs the device
Labelling Identify the hardware
Location Description of the exact location of the system
End customer Operator of the equipment
Configuration Safety-relevant functions of the system, which must be monitored via the safety module
Create Date Date on which the report was created
Function Description of the function or scope of the installation
characteristics
Comments Safety related functions of the devices
Hardware Device names
Step: Single control of the system components
In this area there are checkboxes, which should be marked if the given information is correct.
Visual inspection for mechanical damage and correct mounting:
-
Component documentation is available:
-
Visual inspection for deviations from the installation guidelines:
-
Item Description
Device Type Registration of the Servo Driver type, e.g. A6 Multi.
Serial Number Safety ID (label)
CRC Device Config Signature for the program and the parameter data
Transfer Counter This field can also be edited.
Check the correct function
The test engineer must again validate all the configured data in the printed report by detecting the
programmed functions on the equipment / Servo Driver.
All set limit values of the monitoring functions used must be checked for correctness. The reaction times
specified in the installation manual must be observed.
6-3