WMF Perfect Premium Manual Del Usuario página 41

1. Remove lid handle
5.1 and clean under running water only (see
image series G).
2.
Take the seal ring
L
wash by hand.
3. Soak lightly sticking food, bring strong
sticking foods to a boil with some water in
the pressure cooker.
4.
Clean valves from dirt and/or clogging with a
moist cotton swab.
▶
Do not use any sharp or pointy objects.
5. The pot, inserts and trivet can be cleaned in
the dishwasher.
▶
However, this can lead to discolourations of
the surface. This does not impair function.
▶
Nonetheless, we recommend cleaning by
hand.
6. If lime develops bring vinegar-water to a boil
in the pressure cooker.
7. Dry the cooking utensils well after cleaning.
8.2 Storage
Keep the clean, dry pressure cooker in a
clean, dry and protected environment.
1. Remove lid as described in Chapter 5.1.
6
2.
Remove seal ring
L
store separately to protect it.
3. Remove lid handle
B
5.1 and place in the pot
4. Place the lid upside down on the pot
6
8.3 Maintenance / replacing wear parts
/ Side handle and handle only to be
replaced by WMF Trade / Service team.
/ Safety valve only to be replaced by WMF
Trade / Service team, and at the latest
before 10 years have elapsed.
/ Check wear parts regularly and replace for
original parts if necessary.
64.1168.0790 I 002
Operating Instructions
as described in Chapter
B
out of the lid and
6
from the pot rim and
as described in Chapter
and/or lid .
1 6
1
/ Replace seal ring and double seal if they are
damaged, hardened, discoloured or if they no
longer fit properly.
8.3.1 Replace seal ring
1.
Remove lid
2.
Turn over lid
3. Remove defective seal ring
rim and dispose of it.
4.
Insert new original seal ring
rim and carefully press under the rim.
▶
The seal ring
below the curved pot rim.
8.3.2 Replacing double seal
1.
If necessary, remove lid
described in Chapter 5.1.
2.
Take apart the lid (see image series G), by
turning the lid over
3. Hold the lid
device towards the end of the handle.
E
4.
Remove handle
5.
Remove the double seal
and dispose of it (see Image J).
6. Carefully position the new original double
seal .
I
▶
The double seal
valve.
▶
The arrows on the double seal
handle base must point towards each other.
▶
.
The double seal
flat against the handle base.
▶
The double seal
handle's sealing lip
sealing lip lies over the seal edge.
as described in Chapter 5.1.
6
.
6
from the pot
L
into the pot's
L
must be positioned fully
L
from the pot as
6
.
6
and press the handle locking
6
.
B
from the handle
L
cannot cover any other
L
I
must be gap-free and lay
I
must be situated under the
L
so that the curve of the
K
EN
B
and the
35