Yamaha WR250F Manual De Servicio Del Propietario página 204

1 Clamp
2 Positive battery lead
3 Battery
4 Negative battery lead
5 Taillight coupler
6 CDI unit coupler (6-pin)
7 CDI unit coupler (3-pin)
8 CDI unit coupler (6-pin)
CABLE ROUTING DIAGRAM
È Fasten the wire harness, negative battery lead and starter
motor lead to the upper engine bracket (left side). Locate the
clamp end facing toward the upper side of the frame with the
tie end cut off on the inside of the frame.
É Fasten the wire harness, negative battery lead and starter
motor lead to the upper engine bracket (left side). Locate the
clamp end facing toward the upper side of the frame with the
tie end cut off on the inside of the frame. Clamp the wire har-
ness and negative lead at the marking.
Ê Pass the starter motor lead through the hole in the relay
holder.
Ë Fit the cover securely.
Ì Connect the wire harness to the starter relay.
2 - 111
SPEC