Start And Speed Reference Control - Gram IF 4000 Manual De Uso

Start and Speed Reference Control

The drive speed command can be obtained from a number of different
sources. The source is normally determined by P038
However, when A051 or A052
6, and the digital input is active, A051 or A052 will override the speed
reference commanded by P038
for the override priority.
Jog Input
Enabled and Active:
A051 or A052 = 2
No
Local/Remote Input
Enabled and Active:
A051 or A052 = 5
No
Comm Select Input
Enabled and Active:
A051 or A052 = 6
No
P038 [Speed Reference]
= 4 or 5
No
A051 / A052
Preset Inputs Active
No
Run as specified by
P038 [Speed Reference].
Start and Direction commands come
from P036 [Start Source].
[Digital Inx Sel]
[Speed Reference]. See the chart below
Drive will Start and Run at Jog Speed.
Yes
Direction comes from
Terminal 03 Dir/Run REV
Yes
Start, Speed and Direction commands
come from Integral Keypad.
Yes
Start, Speed and Direction commands
come from RS485 (DSI) port.
Run as specified by
P038 [Speed Reference].
Yes
Start and Direction commands come
from P036 [Start Source].
Run as specified by
A071-A073 [Preset Freq 1-3].
Yes
Start and Direction commands come
from P036 [Start Source].
Installation/Wiring
[Speed Reference].
is set to option 2, 4, 5 or
1-17