Connecting Two Permanent Peripherals; Connecting An Rs-485 Network - Gram IF 4000 Manual De Uso

D-4 RJ45 DSI Splitter Cable

Connecting Two Permanent Peripherals

DSI /MDI Drive
Parameter 9 [Device Type]
set to "Slave" and
connected to Slave port (S)
on RJ45 Splitter Cable

Connecting an RS-485 Network

AK-U0-RJ45-TR1
Terminating Resistor
(end of network)
Both the Master (M) and Slave (S) ports on the RJ45 Splitter
Cable operate as standard RS-485 ports in this configuration.
Panel Mount Unit
Esc Sel
M
S
DSI / MDI Drives
Esc Sel
AK-U0-RJ45-TB2P
Two-position
Terminal Block
Customer supplied RJ45 male-to-RJ45 male
cables with wires connected at pins 4 and 5 only.
NEMA 4
DISP REMOVE
Esc Sel or
LANG
ALT
Jog
|
DSI
Parameter 9 [Device Type] set to
"Master" and connected to Master
port (M) on RJ45 Splitter Cable
Esc
DISP REMOVE
ALT or
Sel
LANG
Jog
|
DSI
Esc Sel
or
NEMA 1 Bezel
with DSI / MDI
Hand Held
DISP LANG REMOVE
Esc Esc Sel Sel
7 8 9 ALT
4 5 6 Jog
1 2 3
. 0 +/-
DSI
DISP LANG REMOVE
Esc Esc Sel Sel
7 8 9
ALT
4 5 6 Jog
1 2 3
. 0 +/-
DSI
or