Using The Emergency Cables; Unauthorised Use; Most Commonly Encountered Vehicle Alignment Faults - SICE A 948 Manual De Instrucciones

Tabla de contenido

Publicidad

Idiomas disponibles
  • ES

Idiomas disponibles

The emergency cables allow the operator to continue working even when the sensor batteries are
flat, in the event of a radio system malfunction or when the calibration procedure is in progress.
The emergency cable set consists of four cables, two of which are 6.5 m long and two 4.5 m long.
One end of the two longer cables must be connected to the connectors provided on the rear of
the central unit (7, fig. 22) and the other end to one of the two connectors on the front sensors
(2, fig. 24). The two shorter cables must be connected to the unused connector on the front
sensors (2, fig. 24) and to the connector on the rear sensors (2, fig. 24).
It is forbidden to use the aligner for any purpose other than measuring the characteristic
alignment angles of a vehicle (see description in the chapter "Characteristic Angles").
Use of the aligner for any purpose other than its original function releases the
manufacturer from all responsibility for any damage or injury that may result.
It is recommended to use the Personal Computer installed in the central unit only with the
programs supplied by the builder.
The software in the HARD DISK and in the update CD ROMs are the property of the builder
and can be used only with the personal computer supplied with the machine.
It is highly recommended not to use the Personal Computer for games or with other
software based on unauthorised copies, to avoid reducing the safety of plants and
persons. This is mandatory to avoid any possible contamination from computer viruses.
In any case, it is recommended to check the compatibility of all original software not supplied by
the builder with an authorised Technical Service Centre.
Do not remove the Personal Computer from its installation position to avoid any damage
to the connections.

MOST COMMONLY ENCOUNTERED VEHICLE ALIGNMENT FAULTS

Cause: tyre side slip.
Invert the position of the wheels on the same axle:
• if the vehicle now tends to wander to the other side, take one of the wheels whose position
you have already inverted and turn the tyre on the rim.

USING THE EMERGENCY CABLES

UNAUTHORISED USE

ATTENTION
ATTENTION
ATTENTION
Vehicle tends to wander to the left or the right.
WARNING
52

Publicidad

Tabla de contenido
loading

Tabla de contenido