Toe Curve Window; Personalise Printout Window; Spoiler Program - SICE A 948 Manual De Instrucciones

The following keys are active in the job record selection screen:
- F1 displays the on-line "Help" function
- F2 returns to the previous screen
- F3 (or "Enter"): advances to the next screen
- F4 to print the list of jobs on record
- F10 returns to the starting screen.
The following keys are active in the screen which compares with saved and current values:
- F1 displays the on-line "Help" function
- F2 returns to the previous screen
- F7 prints the comparison between the saved and current values.
- F10 returns to the starting screen.
The window can be called up from the front axle adjustment window only, by pressing the F8
key, selecting the item "Toe Curve" from the list and pressing the F3 key.
It allows the manual toe curve measurement and adjustment procedure to be performed.
The "preparing vehicles for wheel alignment" window is displayed. Follow the instructions
indicated and press F3.
The toe curve adjustment window is displayed; adjust, then press F3.
The "preparing vehicles for wheel alignment" window is displayed again. Follow the instructions
indicated and press F3 to go back to the front axle adjustment procedure.
The following keys are active in the "preparing vehicles for wheel alignement" window and in the
"Toe curve" window:
- F1 displays the on-line Help
- F2 goes back to the previous window
- F3 (or "Enter") goes to the next window
- F7 displays the vehicle adjustment window
- F10 goes back to the previous window.
Appears at the end of a measurement cycle (fig. 45).
Allows setting of the advertising message that will appear on the printout, together with the
number of copies.
This program allows measurement of angles even on vehicles equipped with especially low
spoilers which block measurement by the front and/or rear transverse goniometer.
If this condition occurs, before display of the "Rear axle measurement and adjustment window", the
screen shows the usual error page (fig. 33) indicating the measurements which are not possible.
The following conditions may occur:
1. Rear spoiler
The user may:
- press key F3 to continue. It will not be possible to calculate the rear axle set back;
- press key F7 to select the "Rear Spoiler program".

TOE CURVE WINDOW

PERSONALISE PRINTOUT WINDOW

SPOILER PROGRAM

42