Instructions For Correct Assembly Of The Radio Units; Ambient Conditions In The Place Of Operation - SICE A 948 Manual De Instrucciones

• Connect the other end of the data cable (USB) to the printer (end with square-section connector).
• Pass the power supply lead through one of the two slots on the upper shelf (PC compartment
shelf) and connect it to one of the Shuko sockets available (fig. 3).
s the printer data cable (USB cable) through one of the two slots on the rear panel.
• Pas
• Connect the printer data cable (USB cable) to a connector located behind the PC (USB port)
as shown in figure 11.
• Make the power supply leads and printer data cables pass on the same side so as to fix the
cables to the adjacent sides of the cabinet with the clamps and supports provided.

Instructions for correct assembly of the radio units

Secure the Hard Lock device to the central unit, at the rear of the machine (A, fig. 18), using the
provided holes.
To assure the most efficient radio communications between the heads and the central unit,
proceed as follows.
Installation:
• Fix the Hard Lock device to the cabinet (A, fig. 18), referring to the diagrams for positioning of
the radio on the central unit (fig. 19 - 20 - 21).
If you are not faced with one of the standard conditions illustrated, place the radio unit
so that it is as "visible" as possible (i.e. with the smallest number of metal obstacles
between the two) to the heads and well away from metal objects which may screen the
electromagnetic waves.
NOTE
If further communication problems are encountered after the radio unit has been positioned
correctly, fix the radio to a wall of the workshop, taking care to position it:
• high up,
• well way from metal objects,
• "visible" to the heads.
If the distance from the central unit increases it is possible to use 16 meter sensor cables, optional).
Relative humidity: 20%
Temperature range: 5°C
The machine must not be operated in potentially explosive atmosphere.

Ambient conditions in the place of operation

90% (without condensation)
÷
35°C
÷
ATTENTION
WARNING
10