SICE A 948 Manual De Instrucciones página 108

N.B.: To move through the different objects (boxes) present on the screen, use
the tab key.
4. With the ↑ or ↓ arrows, select, in the box "B", the disc where you wish to save
"Data Saving".
5. With the ↑ or ↓ arrows, select, in the box "C", the folder where you wish to save
"Data Saving".
6. Press "Enter" ↵ to confirm.
The data filing path is displayed in full in the box "A"
N.B.: the instructions contained from point 7 to 9 inclusive refer to the settings related
to the automatic Backup (see the next note )
7. In the box "D", it is possible to select automatic filing (Data Saving) using the space bar.
8. In the box "E", indicate how often you wish to perform "Data Saving" using the
numeric keypad.
9. In the box "F", it is possible to select whether or not to ask if you wish to perform
automatic filing (Data Saving) pressing the space bar.
10. In the box "G", it is possible to select whether the information (Data Saving) is filed
in compressed format (zip) or as a simple copy of the files, pressing the space bar.
11. After setting your own choices, press "F5"
12. Press F3 to confirm.
13. Press "F2", to exit the "Save Data" settings screen and go back to the "Service"
screen.
14. Press "F2" to go back to the starting screen (logo screen)
Note: The path selected to perform the manual filing is valid exclusively for this filing,
the last path saved remains in the memory, performing the procedure described in the
"Save Data" procedure setting up" section. If you wish to save these settings
permanently, before step 13, follow the instructions contained from point 7 to 9 inclusive
and the carry out the following operations:
C) "Save Data" automatic execution
At the end of the period that was set up, the program automatically performs the "Save
Data" procedure.
The program exclusively prompts for confirmation to perform the procedure if, in the setup
settings, the "Confirmation request before filing" option is selected, in the box "F" figure 51;
otherwise, the procedure is performed without the user noticing anything.
In this case, the confirmation request is setup in the "Save Data" setup; the following
message will be displayed before performing filing, at the end of the period that was set up,
upon aligner start-up: "Data filing...Want to perform it ?".
"Reset Data" procedure (Restore)
The "Reset Data" procedure can be exclusively performed in manual mode.
Before resetting data, the machine performs a backup of the data to be replaced. To restore the
backup, contact the technical assistance service.
a) Pressing "F6"
b) Press "F3" or "Enter" ↵ to confirm.
• Press "F3" if you want to perform the "Save Data" procedure
• Press "F2" if you do not want to perform the "Save Data" procedure
50