Animation Window; Steering Window - SICE A 948 Manual De Instrucciones

This window is recalled by pressing key F7 from the following windows:
- Databank data summary;
- Rear axle adjustment
- Front axle adjustment.
This window is used for playing video clips, which illustrate the procedure for adjusting the
following angles:
- rear toe
- rear camber
- front toe
- toe curve (for Audi/Volkswagen)
- front camber
- caster
king pin inclination (King pin)
-
Certain angles may be adjusted, in which case the corresponding animations will or will not
exist, as indicated by the graphics. To select a video clip, press key F5 or F6 and then press to
switch to F3 step-by-step display.
When the video clip of the adjustment has finished, key F5 or F6 can be used to scroll through
the various steps of the procedure.
To switch from step-by-step viewing mode to selection of an angle video clip for display, use the
"Tab" or "Shift" + "Tab" keys.
The following keys are active in this screen:
- F1 displays the on-line "Help" function
- F2 (or "Esc"): halts playback of the clip or returns to the previous screen
- F3 (or "Enter"): starts or replays the clip
- F5 Scrolls down through the adjustment selection list /moves on one step in display of the
clip for an adjustment.
- F6 Scrolls up through the adjustment selection list /moves back one step in display of the
clip for an adjustment.
- F10 returns to the starting window.
For executing the 10° or 20° steering for calculating: caster, king pin inclination, included angle,
toe-out on turn at 20° (fig. 31).
When electronic turntables are installed, the maximum steering angle can also be measured.
The following keys are active in this window:
- F1 invokes on-line "Help"
- F2 returns to the previous screen
- F3 advances to the next screen
- F4 sets up:
 Unit of measurement
Angles

Grades
•
Degrees
•
 Wheel aligner
Electronic turntables enabled;

Always;
•

ANIMATION WINDOW

STEERING WINDOW

36