SICE A 948 Manual De Instrucciones página 80

Displays the next page, the windows which contain a large amount of information
are divided into pages. (E.g. On-line help, job record management, etc.)
Displays the Smart Card "Data Form" window (only available in the Diagnostics
window)
Displays the job record management window
Resets any steering wheel alignment correction values already in the memory
On/off function for maximum steering angle check (only available if electronic
turntables have been enabled in the setup). Enabled option When the option is
enabled an icon displaying a turntable appears in the top right-hand corner of the
heading bar.
Prints the current window.
Carries out a data backup (makes a reserve copy of the data present in the file).
Carries out a data restore (carries out a data reset, replacing the data available in
the file with those saved previously).
Stores the set configuration.
Perform standard programming (with default settings) of the radio modules
operating at 2.4 GHz
Switches between display of the caster, total toe and setback adjustment boxes.
(only available in the front axle adjustment window).
Switches between display of the camber, track difference and setback
adjustment boxes. (only available in the rear axle adjustment window).
Accesses and performs the procedure for update of the enabled programs, using
the smart card (in the service procedure)
Runs the front spoiler procedure (the key only appears when the front transverse
goniometers do not give a reading)
Accesses the sensor zero-calibration procedure
Deletes the selected datum (a Make, Vehicle, Customer or Job)
Loads the data of the last job saved into the memory
No job available for loading into the memory
22