SICE A 948 Manual De Instrucciones página 91

The following keys are active in this screen:
- F1 displays the on-line "Help" function
- F2 returns to the previous window
- F3 starts the selected ROC procedure (to move on to the next screen if the ROC Skip or
ROC Recall procedure has been selected)
- F4 sets up the desired type of default compensation procedure and selects the vehicle weight
unit of measurement:
 Roc
Roc

• "three-point ROC"
• "Push-mode ROC" (90-degree displacement)
• "ROC skip"
• "ROC Recall"
 unit of measurement:
Weight

• Kilograms
• Pounds
- F5 used to scroll downward through the list of ROC options available
- F6 used to scroll upward through the list of ROC options available
- F10 returns to the starting window.
1. Lift the vehicle.
2. Check that the wheels (or one wheel) are able to turn freely and that the sensors are
switched on and not locked.
3. Press the "ROC" key (6, fig. 25) of the sensor on which you wish to perform the ROC
procedure. An hourglass appears on the screen to indicate the start of the measurement;
when the hourglass disappears and the "OK" message appears on wheel concerned, the
initial position (0°) of that wheel has been saved in memory.
Important: Do not touch the sensors during the measurement data acquisition phase.
4. Manually turn the wheel by 90° following the instructions (fig. 28)
Important: Turn the wheel always, and only, in the clockwise direction.
5. Press the sensor "ROC" button again (6, fig. 25) to have the sensor store the position.
6. Wait for the audible signal and for the "OK" message to appear, indicating that the "90°"
position has been saved in memory.
7. Manually turn the wheel by another 90° in the same direction.
Important: Turn the wheel always, and only, in the clockwise direction.
8. Press the sensor "ROC" button again (6, fig. 25) to have the sensor store the position.
9. Wait for the audible signal and for the "OK" message to appear, indicating that the "180°"
position has been saved in memory.
10. Repeat steps 3, 4, 5, 6, 7, 8, 9 for the other wheels.
Notes
• Turn the wheel exclusevely in the clockwise direction.
• The compensation of a wheel can be repeated by pressing the "ROC" key of the
corresponding sensor.
Performing "3-point ROC"
33