Electrical Hook-Up - SICE A 948 Manual De Instrucciones

The manufacturer presets the aligner to operate with a power supply of 230 VAC.
It can be preset to operate on 115 VAC by setting the PC voltage change switch as appropriate.
NOTES
- However, it is important to check that the monitor and printer are preset to operate with
voltages other than 230 VAC.
- The power supply cable supplied with the machine complies with the relevant regulations.
All electrical hook-up operations to the main power supply must be exclusively carried
out by qualified electricians.
• The electrical supply line must be suitably sized in relation to:
1. the machine's power draw, as specified on the machine data plate.
2. the distance between the machine and the electric hook-up point, in order that the voltage
drop at full charge does not exceed 4% (10% during the starting phase) in relation to the
nominal value of the voltage on the machine data plate.
• The user must:
1. provide a power cord in appliance with local electrical regulations
2. connect the machine to a dedicated power line with its own 30 mA circuit breaker
3. install fuses on the power supply line, suitably dimensioned according to the indications in
the general electric diagram in this manual
4. make sure that the workshop is provided with an efficient ground circuit.
• In order to prevent the machine being used by unauthorized personnel, it is advised to
disconnect the power supply plug when the machine remains idle (switched off) for long
periods of time
• If the machine is hooked up directly to the main control board, without a separate plug to
socket connection, a key switch or a switch that can be locked out must be installed to
prevent the machine from being used by persons other than those authorized.
For correct and safe operation of the machine it must be connected to an efficient
ground circuit.
NEVER connect the ground wire to a gas pipe, water pipe, telephone line or other
makeshift system.
Before connecting the power plug to the power panel make sure that the line voltage is
the same as the power supply indicated on the machine's data plate.

ELECTRICAL HOOK-UP

WARNING
WARNING
WARNING
11