Installing The Printer - SICE A 948 Manual De Instrucciones

Sensors are fitted with Ni-Mh batteries, which therefore do not memorise the charge
cycle. They can be charged at any moment.
The first time, fully charge the batteries, remove the sensors for 10/15 minutes after
the charge, then charge completely again.
• On the sides of the cabinet, above the recharging supports there are:
- one green LED(1, fig. F2), located only on the left side, which indicates the presence of
voltage on the recharging terminal boards.
- two recharging buttons (2, fig. F2), one per measuring sensor. If pressed two times
consecutively, the measuring sensor will start recharging.
- two orange recharging LEDs (3, fig. F2), one per measuring sensor. When on, indicates
that the measuring sensor is recharging
One complete recharging cycle lasts 4 hours.
When the connections are complete, fit the rear panel.
Position the included STEERING WHEEL HOLDER and BRAKE PEDAL DEPRESSOR
accessories on the support brackets positioned on the back of the cabinet (see fig. 8).
NOTE
Arrange the various connection cables tidily, laying them along logical routes and avoiding
unnecessary extra length or tangles (see fig. 13); tie them together with clamps in various points
if necessary.
For additional information about the technical characteristics, warnings, maintenance
and any other data about the monitor or the printer, read the relative operator's manuals
supplied with machine documentation.
The Windows operating system supports the installation of the majority of printers available on
the market.
Warning !
Some latest-generation printers may conflict (when two or more printers are installed on the
same personal computer).
The manufacturer pre-installs one model of printer; if the printer supplied is of this model once
the connection has been made it will be ready for use.
If the printer is of a different model it must be installed, following the instructions provided in the
installation and setup manual provided with the printer itself.
To avoid problems when using printers not supplied by the manufacturer, it is best to uninstall
all models of printer previously installed before installing a new model. The aligner is preset to
use an 80 column, size A4, colour printer.
During installation the aligner must be turned off.
• Open the front door of the cabinet (A, fig. 17) and place the printer in the compartment
provided (Fig. 17).
ATTENTION

Installing the Printer

ATTENTION
9