SICE A 948 Manual De Instrucciones página 75

Each sensor is equipped with a rechargeable battery which, when fully charged, is able to
operate for approximately 8 hours.
To recharge the batteries, have to put the sensors in the battery charger placed on the cabinet.
In order to avoid running down the battery, the sensors automatically switch off after
approximately five or ten minutes of inactivity (the automatic switch-off time depends on the
conditions in which the sensors are not used, as explained in the "Sensors" section below),
keeping in memory the data calculated up until that time.
At the time of automatic switch-off an audible warning is sounded to alert the operator.
Each sensor must be positioned exclusively on the vehicle wheel indicated on the adhesive
data plate affixed to the sensor.
Fig. 24
12 - Sensor lock/release lever
13 - Clamping knob
14 - Battery charging contacts
15 - Rechargeable battery compartment
16 - Sensor keyboard
17 - Cable connector
18 - Electronic turntable cable connector
19 – Goniometers
• Description of keys and sensor keypad functions (fig. 25)
1) Red LED: indicates that the sensor is not levelled and must be moved in the direction
shown by the arrow
2) Green LED: indicates that the sensor is leveled
3) Green LED: flashes to indicate that radio or cable communications are in progress.
4) Sensor on/off button
This button is combined with a beep which sounds to indicate that the sensor has switched
off; at the same time, the green LED (5, fig. O) beside the button goes out.
One beep and illumination of the LED indicates that the front left-hand sensor has switched
on, two beeps indicate that the front right-hand sensor has switched on, three beeps that the
rear right-hand sensor has switched on and four beeps that the rear left-hand sensor has
switched on.
5) Green LED: indicates that the sensor is on.
Flashes to indicate that the battery charge level is too low.
6) ROC button.
7) Yellow LED: indicates the ROCstatus. If it flashes, sensor ROCmeasurement is in
progress, if it is constantly on the system is ready to move on to a further stage, and if it is
off the ROCprocedure is disabled.
This LED is combined with a beeper: one beep means
17