SICE A 948 Manual De Instrucciones página 109

To perform the "Reset Data" (Restore) procedure, follow the instructions below thoroughly:
1. From the starting screen (Logo screen), press "F8"
2. Select the "Reset Data" option with the ↑ or ↓arrows
3. Press "F3" or "Enter" ↵ to confirm.
The screen on figure 53 will be displayed
N.B.: To move through the different objects (boxes) present on the screen, use
the tab key.
The program always suggests restoring the last "Save Data" procedure performed
(obviously, if the path is available, it may not be available if the "Save Data" is
performed on a removable device; for example, an USB support).
If you wish to select the disc and the folder where to restore the "Save Data"
procedure, proceed as follows; otherwise, proceed from step 4.
N.B.: The destination path of the files to be restored, not set, regarding the restore
program, automatically positions the file in the correct work position.
a) With the ↑ or ↓ arrows, select, in the "B" box Figure 53, the disc where
b) With the ↑ or ↓ arrows, select, in the "C" box Figure 53, the folder where
c) Press "F3" to confirm.
d) The path where to restore the data filed is displayed in full in the box "A"
4. In the "Reference Reset" "D" Figure 53, the identification data (Day, month, year,
time) about when the "Save Data" procedure selected to be restored is performed
are indicated.
5. Press "F5" to confirm.
The "Want to continue?" message will be displayed.
I. Press "F3" if you want to reset data filed
Il. Press "F2" if you do not want to reset data filed.
Once the reset data filed procedure is complete, the program will indicate that it is not
necessary to restart to allow the software to reorganise the data just reset.
6. Press "F3"
7. Press "F2" to exit the "Reset Data" screen and go back to the "service" screen.
8. Press "F2" to exit the "service" screen and go back to the starting screen (Logo
screen)
9. Press "F10" to switching off the computer.
10. Press "F2" to confirm computer switching off.
11. Switch on the computer
Wait until the aligner program finishes data reorganization before operating.
the "Save Data" procedure to be restored is located.
the "Save Data" procedure to be restored is located.
The name of the folder to be searched is generated following the rules
below:
for example: BU_31102006_170653 where
BU_ indicates BackUp
31102006_ indicates ddmmyyyy
170653 indicates hhmmss
Figure 53.
51