Maintenance - SICE A 948 Manual De Instrucciones

Transducer values are fluctuating too violently.
• Make sure that the vehicle is stably positioned and wait.
The monitor displays one or more sensors with a yellow triangle containing an
• Check that the sensor is not turned off.
• Check communications using the emergency cables, to ensure that the radio system is not
malfunctioning
The sensors fail to transmit but no error message appears on the monitor.
• Check that "Demo" operating mode has not been set.
Compensation routine performed incorrectly.
• Repeat compensation taking care that the corresponding wheel on the opposite side of the
vehicle does not rotate or steer (in the case of steer wheels).
• Calibrate the sensors.
The builder declines all liability for claims deriving from the use of non-original spares or
accessories.
Before making any adjustments or performing maintenance, disconnect the electrical
supply from the machine and make sure that all moving parts are suitably immobilised.
Do not remove or modify any parts of this machine except in the case of service
interventions.
Keep the working area clean.
Do not clean the machine with compressed air or jets of water.
When cleaning the area take steps to avoid raising dust as far as possible.
• Store the sensors carefully in a dry place when not in use, to avoid loss of calibration with
consequent measurement inaccuracy.
• Calibrate the sensors at least once every 6 months.
• Keep the sensor glass covers clean (use a soft cloth, do not remove or scratch).
• Keep the turntables and the oscillating footboards on which the vehicle alignment is performed
perfectly clean and do not oil or grease them.
The sensor fails to execute ROC.
exclamation point.
Steering wheels not straight.
Sensors out of calibration.

MAINTENANCE

WARNING
WARNING
ATTENTION
55