Measurement Summary Window - SICE A 948 Manual De Instrucciones

Length

Millimetres
Inches
Angles

Grades
Degrees
 Alignment procedure
Adjustment with car raised

• On;
• Off;
- F5 enables/disables execution of the "Jack & Hold" procedure
- F6 switches between display of the caster, Total Toe and Setback adjustment boxes (set back)
- F7 displays the animation window
- F8 displays a window with a list of working windows. Used for skipping quickly between
windows.
- F10 returns to the starting window.
Notes
If the steering angle procedure has not been performed, the caster adjustment boxes are
•
displayed completely empty.
• If the steering angle procedure has been performed and the front adjustment window is
accessed with the front sensors not levelled, the caster adjustment boxes are displayed
completely empty, with the sensor not levelled warning sign beside them. Level the sensors
to display the contents of the adjustment box (in this case it is not necessary to press the
caster measurement value freeze key F9, because the software automatically performs this
operation invisibly).
• During the caster adjustment, in cases where the variation is very great, the inclination of the
front sensor may induce a non-negligible error in the calculated toe and set back values. If
this condition occurs at the end of the adjustment, it is recommended to proceed as follows:
- press F9 to lock (freeze) the displayed caster value (shown on yellow background);
- position the sensor in a visually horizontal position (level);
- press F6 again to unlock the caster value;
- adjust the toe.
• If a clamp or a wheel had to be demounted in order to adjust caster or camber, a new
compensation must be performed on that wheel. The only type of compensation (ROC) that
can be performed out of the ROC environment - consult the "Compensation" (ROC) window
paragraph - is the three-point ROC.
The measurement summary window (fig. 48) can be called up from different parts of the program by
pressing the F8 key, selecting the "Data Summary" option from the list and pressing the F3 key.
This window shows the tolerance value and current adjustment measurements of all the
vehicle's axles.
The following keys are active in this window:
- F1 displays the on-line "Help" function
- F2 returns to the previous window
- F3 (or "Enter"): advances to the next window
- F4 sets the units of measurement
Toe angle

Degrees;

MEASUREMENT SUMMARY WINDOW

40