SICE A 948 Manual De Instrucciones página 83

Wheelbase and track: (Displays the window containing the wheelbase and
track measurement for the vehicle being tested).
Previous jobs (Displays the window containing the list of jobs saved previously,
to allow comparison with the current measurement).
Toe curve: (puts into execution the toe curve adjustment procedure).
SYMBOL
Demo: (sets the aligner program to work in demo mode, without using the
sensors).
Crooked Steering Wheels: (Starts the crooked steering wheel adjustment
procedure).
Sensor calibration: (Displays the window for selection of the various sensor
control and calibration procedures).
Sensor test: (Displays the sensor test window).
Technical Assistance: (Displays the window for diagnostics, sensor setup,
reading of the enabled smart card settings and radio module setup).
Job Count: (puts into execution the visualisation of the jobs performed by the
wheel aligner; the visualisation is protected with a password). This function is
visible only if enabled in the wheel aligner general setup.
Radar adjustment: (displays a selection window where the type of rader you
wish to align can be selected). This function is optional. It can be enabled by
purchasing an additional AVP or MBP enabling kit.
Data saving (Backup): (visualises the window for the manual execution and/or
automatic execution setting of the data Backup procedure).
Data reset (Restore): [visualises the execution window for resetting the data
(Restore)].
SYMBOL
3-point ROC: (Selects three-point ROC. This procedure saves three positions for
each wheel, for ROC calculation). The procedure can also be carried out on each
individual sensor, when it is fitted to the wheel, even if the other sensors have not
yet been fitted on the other wheels.
Push-mode ROC: (selected to perform the ROC without removing the vehicle's
wheels from the lift or from the floor). It is performed by pushing the vehicle
backward for 90°, confirming the position by pressing the ROC button on a head,
then, moving the vehicle forward, until it reaches the initial position, confirming
again the position by pressing the ROC button on a head.).
ROC skip: (The working procedure moves on straight to the working windows,
without performing the ROC calculation).
MENU AVAILABLE IN SERVICE STATUS
FUNCTION DESCRIPTION
MENU AVAILABLE IN THE ROC STATUS
FUNCTION DESCRIPTION
25