Previous Jobs Window; Toe Curve Window; Personalise Printout Window - SICE A 926 Manual De Instrucciones

Pounds
•
- F10 returns to the starting window.
The window can be called up from different parts of the program by pressing the F8 key,
selecting the "Previous Jobs" option from the list and pressing the F3 key.
If the job record (at least the registration number) has been filled in for the vehicle being
measured, when this function is accessed the program displays the list of jobs already saved for
the vehicle; otherwise, it displays the full list of all the jobs on record, to allow selection of the
job required.
After selecting the memorised job for display, press F3 and the screen will display all the values
saved and the values currently measured, to allow easy comparison, so any shifts in the
vehicle's geometry can be identified at a glance.
The following keys are active in the job record selection screen:
- F1 displays the on-line "Help" function
- F2 returns to the previous screen
- F3 (or "Enter"): advances to the next screen
- F4 to print the list of jobs on record
- F10 returns to the starting screen.
The following keys are active in the screen which compares with saved and current values:
- F1 displays the on-line "Help" function
- F2 returns to the previous screen
- F7 prints the comparison between the saved and current values.
- F10 returns to the starting screen.
The window can be called up from the front axle adjustment window only, by pressing the F8
key, selecting the item "Toe Curve" from the list and pressing the F3 key.
It allows the manual toe curve measurement and adjustment procedure to be performed.
The "preparing vehicles for wheel alignment" window is displayed. Follow the instructions
indicated and press F3.
The toe curve adjustment window is displayed; adjust, then press F3.
The "preparing vehicles for wheel alignment" window is displayed again. Follow the instructions
indicated and press F3 to go back to the front axle adjustment procedure.
The following keys are active in the "preparing vehicles for wheel alignment" window and in the
"Toe curve" window:
- F1 displays the on-line Help
- F2 goes back to the previous window
- F3 (or "Enter") goes to the next window
- F7 displays the vehicle adjustment window
- F10 goes back to the previous window.
Appears at the end of a measurement cycle (fig. 45).
Allows setting of the advertising message that will appear on the printout, together with the
number of copies.

PREVIOUS JOBS WINDOW

TOE CURVE WINDOW

PERSONALISE PRINTOUT WINDOW

41