Installing The Printer; Instructions For Correct Assembly Of The Radio Units - SICE A 926 Manual De Instrucciones

• Fit the 4 measuring head supports (A, fig. 15) to the sides of the cabinet using the
corresponding holes and the 2 Allen screws provided. Closed the holes with the supplied
caps (Figg. 6-10).
• When the connections are complete, fit the rear panel (A, fig. 14).
NOTE
Arrange the various connection cables tidily, laying them along logical routes and avoiding
unnecessary extra length or tangles (see fig. 13); tie them together with clamps in various points
if necessary.
For additional information about the technical characteristics, warnings, maintenance
and any other data about the monitor or the printer, read the relative operator's manuals
supplied with machine documentation.
The Windows operating system supports the installation of the majority of printers available on
the market.
Warning !
Some latest-generation printers may conflict (when two or more printers are installed on the
same personal computer).
The manufacturer pre-installs one model of printer; if the printer supplied is of this model once
the connection has been made it will be ready for use.
If the printer is of a different model it must be installed, following the instructions provided in the
installation and setup manual provided with the printer itself.
To avoid problems when using printers not supplied by the manufacturer, it is best to uninstall
all models of printer previously installed before installing a new model. The aligner is preset to
use an 80 column, size A4, colour printer.
During installation the aligner must be turned off.
• Open the drawer of the cabinet (B, fig. 15) and place the printer in the compartment (Fig. 15).
• Connect the other end of the data cable (USB) to the printer (end with square-section connector).
• Pass the power supply lead through one of the two slots on the rear panel and connect it to
one of the Shuko sockets available (fig. 3).
• Pass the printer data cable (USB cable) through one of the two slots on the rear panel.
• Connect the printer data cable (USB cable) to a connector located behind the PC (USB port)
as shown in figure 11.
• Make the power supply leads and printer data cables pass on the same side so as to fix the
cables to the adjacent sides of the cabinet with the clamps and supports provided.

Instructions for correct assembly of the radio units

Secure the Hard Lock device to the central unit, at the rear of the machine (B, fig. 16), using the
provided holes.
To assure the most efficient radio communications between the heads and the central unit,
proceed as follows.
ATTENTION

Installing the Printer

ATTENTION
9