Measurement Summary Window - SICE A 926 Manual De Instrucciones

Notes
If the steering angle procedure has not been performed, the caster adjustment boxes are
•
displayed completely empty.
• If the steering angle procedure has been performed and the front adjustment window is
accessed with the front measuring heads not levelled, the caster adjustment boxes are
displayed completely empty, with the measuring head not levelled warning sign beside them.
Level the measuring heads to display the contents of the adjustment box (in this case it is not
necessary to press the caster measurement value freeze key F9, because the software
automatically performs this operation invisibly).
• During the caster adjustment, in cases where the variation is very great, the inclination of the
front measuring head may induce a non-negligible error in the calculated toe and set back
values. If this condition occurs at the end of the adjustment, it is recommended to proceed as
follows:
- press F9 to lock (freeze) the displayed caster value (shown on yellow background);
- position the measuring head in a visually horizontal position (level);
- press F6 again to unlock the caster value;
- adjust the toe.
• If a clamp or a wheel had to be demounted in order to adjust caster or camber, a new
compensation must be performed on that wheel. The only type of compensation (ROC) that
can be performed out of the ROC environment - consult the "Compensation" (ROC) window
paragraph - is the three-point ROC.
The measurement summary window (fig. 48) can be called up from different parts of the program by
pressing the F8 key, selecting the "Data Summary" option from the list and pressing the F3 key.
This window shows the tolerance value and current adjustment measurements of all the
vehicle's axles.
The following keys are active in this window:
- F1 displays the on-line "Help" function
- F2 returns to the previous window
- F3 (or "Enter"): advances to the next window
- F4 sets the units of measurement
Toe angle

Degrees;
•
Length;
•
Setback and Track Difference

Degrees
•
Length
•
Length

Millimetres
•
Inches
•
Angles

Grades
•
Degrees
•
Pressure

Bar
•
Psi
•
Weight

Kilograms
•

MEASUREMENT SUMMARY WINDOW

40