Jack & Hold Program; Utility Procedures Window - SICE A 926 Manual De Instrucciones

If the front and rear spoilers are fitted, independently from the spoiler procedure selected, at the
end of the procedure on the axle selected, the program will indicate that the spoilers are fitted
and will ask you if you wish to perform the procedure on the other axle.
It is possible to choose whether or not to perform the second spoiler procedure, which, in this
way, will allow set back measurement on both axles.
During execution of the Spoiler program, the following keys are active:
- F1 to display the on-line "Help" function
- F2 to return to the previous window
- F3 to store the first measuring head camber value after it has been lowered
- F10 returns to the starting window.
Notes
If the vehicle on which the measurement is being performed is fitted with very low front and rear
spoilers that impede the measurement of the measuring head transverse goniometers, the
double spoiler procedure is requested in the caster measurement window so as to allow the
wheel to be aligned before starting steering.
This program is started by selecting the corresponding F4 menu option from the wheel aligner
program starting window.
It allows the vehicle's characteristic angles to be adjusted with the axle concerned lifted, by first
locking ("freezing") the value displayed for the lowered vehicle, so that the variations caused by
the lifting operation are ignored.
Follow the graphic prompts on the screen, described below:
- press F5 with the vehicle lowered to lock (freeze) the values;
- level all measuring heads;
- lift the vehicle;
- level all measuring heads again;
- press the F3 key to confirm that the vehicle has been lifted;
- perform the adjustment;
- press the F5 key again to lock (freeze) the values again;
- level all measuring heads;
- lower the vehicle;
- level all measuring heads again;
- press the F3 key again to confirm that the vehicle has been lowered.
The service window is accessed by pressing key F8 from the wheel aligner program starting window.
A list of the options available is displayed:
• Demo;
• Crooked steering wheels;
• Measuring head calibration;
• Measuring head Test;
• Technical Assistance;
• Job Count (if enabled in the wheel aligner general setup – F4 from the Logo page).
Select an option and press F3 to access the chosen procedure.
JACK & HOLD PROGRAM

UTILITY PROCEDURES WINDOW

43