Technical Assistance; Job Count; Save Data (Backup) And Reset Data (Restore) Procedure - SICE A 926 Manual De Instrucciones

Tabla de contenido

Idiomas disponibles

Press the F5 key to display the release of the software installed on the measuring heads.

The release appears in the top box of each window dedicated to each measuring head.

The following keys are active in this window:

- F1

displays the on-line "Help" function

- F2

returns to the previous window

- F5

switches from the current window to the window with the software information and vice-versa.

- F10 returns to the starting menu window.

Window for use by the technical support service only.

Users are urged not to access this window. Improper use of the procedures in this program

section may cause aligner malfunctions.

This option is visible only if previously enabled in the wheel aligner general setup.

To access the "Job Count" window, enter the password (the password is not indicated in this

manual for security reasons). If interested in this option, please request the password from the

support service.

The window (fig. 50) is divided into two sections: the left section displays the overall count of the

job performed, the right section shows the job count per day. A calendar is also displayed,

where the desired visualisation date can be selected.

Three boxes are located above the calendar, where the desired day, month and/or year can be

selected for rapid selection of the date searched. After setting the date, confirm the selection by

pressing the "Enter" key

This window behaves like message windows, where the active function keys are in the window,

whereas the function bar keys are disabled.

The following keys are active in this window:

- F2

goes back to the previous window

- F4

resets the overall job count to zero.

Notes

When resetting the overall job count to zero, only the overall count is reset to zero, while the

number of jobs saved every day is not altered.

SAVE DATA (BACKUP) AND RESET DATA (RESTORE)

For the versions that support it, the "Save data" (Backup) and "Reset data" (Restore) function is

available.

The program can "Save data" in any valid disc (Hard Disk, USB support, etc.)

The Program manages data saving and keeps available the last five saves on the local disc

drive (Disc C, Disc D, etc. corresponding to the permanent disc drives - Hard Disk- installed on

the PC). Regarding the removable discs, (USB support, etc.), no check is carried out.

During the different situations described in the following sections, some messages reported

below may be displayed to simplify the description of the each operation:

Message

"Operation successful"