Rear Axle Measurement And Adjustment Window - SICE A 926 Manual De Instrucciones

Take care over the AIRBAG safety system and steering wheel position
measuring heads, if installed.
In all cases, the measuring head levelling device readings are displayed.
Carry out all the operations indicated by the icons
Press key F3 (Enter) to confirm and advance to the next screen.
At this point the system acquires and saves the "diagnostic" data for the vehicle, i.e. the values
describing the state of the vehicle prior to adjustment.
These values are then shown on the screen of the measurement data summary table.

REAR AXLE MEASUREMENT AND ADJUSTMENT WINDOW

Displays the measured angles for the rear vehicle axis and the reference adjustment tolerances
(fig. 32).
The values are continually updated to guide the operator performing the adjustment.
The following keys are active in this window:
- F1 invokes on-line "Help"
- F2 returns to the previous window
- F3 (or Enter) advances to the next window
- F4 sets:
 Unit of measurement
Toe angle

• Degrees;
• Length;
Length

• Millimetres
• Inches
Angles

• Grades
• Degrees
 Alignment procedure
Adjustment with car raised

• On;
• Off;
- F5 enables/disables execution of the "Jack & Hold" procedure
- F6 switches between display of the camber, Track Difference and Setback adjustment boxes
(set back).
- F7 displays the animation window
- F8 displays a window with a list of working windows. Used for skipping quickly between
windows.
- F10 returns to the starting window.
Notes
• The numeric values are colour-coded as follows:
- Red background: value outside the permitted tolerance range;
- Green Background: value within the permitted tolerance range;
- Blue background: value with no associated reference tolerance range;
38