SICE A 926 Manual De Instrucciones página 108

permanently, before step 13, follow the instructions contained from point 7 to 9 inclusive
and the carry out the following operations:
C) "Save Data" automatic execution
At the end of the period that was set up, the program automatically performs the "Save
Data" procedure.
The program exclusively prompts for confirmation to perform the procedure if, in the setup
settings, the "Confirmation request before filing" option is selected, in the box "F" figure 51;
otherwise, the procedure is performed without the user noticing anything.
In this case, the confirmation request is setup in the "Save Data" setup; the following
message will be displayed before performing filing, at the end of the period that was set up,
upon aligner start-up: "Data filing...Want to perform it ?".
"Reset Data" procedure (Restore)
The "Reset Data" procedure can be exclusively performed in manual mode.
Before resetting data, the machine performs a backup of the data to be replaced. To restore the
backup, contact the technical assistance service.
To perform the "Reset Data" (Restore) procedure, follow the instructions below thoroughly:
1. From the starting screen (Logo screen), press "F8"
2. Select the "Reset Data" option with the ↑ or ↓arrows
3. Press "F3" or "Enter" ↵ to confirm.
The screen on figure 53 will be displayed
N.B.: To move through the different objects (boxes) present on the screen, use
the tab key.
The program always suggests restoring the last "Save Data" procedure performed
(obviously, if the path is available, it may not be available if the "Save Data" is
performed on a removable device; for example, an USB support).
If you wish to select the disc and the folder where to restore the "Save Data"
procedure, proceed as follows; otherwise, proceed from step 4.
N.B.: The destination path of the files to be restored, not set, regarding the restore
program, automatically positions the file in the correct work position.
a) With the ↑ or ↓ arrows, select, in the "B" box Figure 53, the disc where
b) With the ↑ or ↓ arrows, select, in the "C" box Figure 53, the folder where
c) Press "F3" to confirm.
d) The path where to restore the data filed is displayed in full in the box "A"
a) Pressing "F6"
b) Press "F3" or "Enter" ↵ to confirm.
• Press "F3" if you want to perform the "Save Data" procedure
• Press "F2" if you do not want to perform the "Save Data" procedure
the "Save Data" procedure to be restored is located.
the "Save Data" procedure to be restored is located.
The name of the folder to be searched is generated following the rules
below:
for example: BU_31102006_170653 where
BU_ indicates BackUp
31102006_ indicates ddmmyyyy
170653 indicates hhmmss
Figure 53.
50