Scrapping; Environmental Information - SICE A 926 Manual De Instrucciones

The Manufacturer declines all liability for claims deriving from the use of non-original
spares or accessories.
Before making any adjustments or performing maintenance, disconnect the electrical
supply from the machine and make sure that all moving parts are suitably immobilised.
Do not remove or modify any parts of this machine except in the case of service
interventions.
Keep the working area clean.
Do not clean the machine with compressed air or jets of water.
When cleaning the area take steps to avoid raising dust as far as possible.
• Store the measuring heads carefully in a dry place when not in use, to avoid loss of calibration
with consequent measurement inaccuracy.
• Calibrate the measuring heads at least once every 6 months.
• Keep the measuring head glass covers clean (use a soft cloth, do not remove or scratch).
• Keep the turntables and the oscillating footboards on which the vehicle alignment is performed
perfectly clean and do not oil or grease them.
If the machine is to be scrapped, remove all electrical, electronic, plastic and metal components
and dispose of them separately, as provided for by local legislation (see figs. 54 - 54a).
Following disposal procedure shall be exclusively applied to the machines having the crossed-
out bin symbol on their data plate
This product may contain substances that can be hazardous to the environment or to human
health if it is not disposed of properly.
We therefore provide you with the following information to prevent releases of these substances
and to improve the use of natural resources.
For this purpose the electrical and electronic equipment producers and distributors set up proper
collection and treatment systems for these products.
At the end of life your product contact your distributor to have information on the collection
arrangements.

SCRAPPING

ENVIRONMENTAL INFORMATION

Electrical and electronic equipments should never be disposed of in the
usual municipal waste but must be separately collected for their proper
treatment.
The crossed-out bin symbol, placed on the product and in this page, remind
you of the need to dispose of properly the product at the end of its life.
In this way it is possible to prevent that a not specific treatment of the
substances contained in these products, or their improper use, or improper
use of their parts may be hazardous to the environment or to human health.
Furthermore this helps to recover, recycle and reuse many of the materials
used in these products.
WARNING
ATTENTION
55