Vehicle Make And Model Selection Window - SICE A 926 Manual De Instrucciones

VEHICLE MAKE AND MODEL SELECTION WINDOW

If display of the vehicle make and model selection window has been set as part of the operating
sequence in the machine setup, this window appears automatically. It allows the user to select the
make of the vehicle using the procedures described in the paragraph "General Considerations".
The following keys are active in this window:
- F1 displays the on-line "Help" function
- F2 returns to the previous screen
- F3 (or "Enter"): confirms selection of a make and advances to model selection window
- F4 chooses whether to display:
Makes/models file

• all the available makes;
• only makes from the primary databank;
• only user-defined makes in the secondary (personalised) databank.
Markets

• Argentina
• Brazil
• China
• Europe
• Japan
• Korea
• Asia
• North Africa
• North America
• Oceania
• South Africa
• South America
Listing order

• Alphabetical
• By date
Vehicle description

• Commercial
• Manufacturer
- F6 modifies a previously entered make (only for user-entered makes)
- F7 deletes a previously entered make (only for user-entered makes if there are no
associated models)
- F8 enters a new make (see paragraph "Enter/Modify window")
- F10 returns to the starting window.
Notes
• The aligner cannot be operated unless a hardware protection key (SIM) has been inserted.
• The main protection circuit board configured for the basic version is supplied with the
machine.
For the wheel aligner to operate, the main card must always be present and fitted into the
slot inside the unit; in case of malfunction, make sure that the reader is wired correctly
as described in the operator's manual.
ATTENTION
30