Safety Regulations - SICE A 926 Manual De Instrucciones

2. connect the machine to a dedicated power line with its own 30 mA circuit breaker
3. install fuses on the power supply line, suitably dimensioned according to the indications in
the general electric diagram in this manual
4. make sure that the workshop is provided with an efficient ground circuit.
• In order to prevent the machine being used by unauthorized personnel, it is advised to
disconnect the power supply plug when the machine remains idle (switched off) for long
periods of time
• If the machine is hooked up directly to the main control board, without a separate plug to
socket connection, a key switch or a switch that can be locked out must be installed to
prevent the machine from being used by persons other than those authorized.
For correct and safe operation of the machine it must be connected to an efficient
ground circuit.
NEVER connect the ground wire to a gas pipe, water pipe, telephone line or other
makeshift system.
Before connecting the power plug to the power panel make sure that the line voltage is
the same as the power supply indicated on the machine's data plate.
Failure to observe these instructions and the relative danger warnings can cause serious
injury to the operator and others.
Do not power up the machine before you have read and understood all the
danger/warning notices in this manual.
This machine must be used only by qualified and authorized personnel. A qualified operator is
considered to be a person who has read and understood the manufacturer's instructions, is
suitably trained, and is conversant with safety and adjustment procedures to be adhered to
during operations.
Operators are expressly forbidden from using the machine under the influence of alcohol or
drugs capable of affecting physical and mental capacity.
The operator must:
• Read and understand all instructions on how to use the machine.
• Make sure to have a thorough knowledge of the capabilities and characteristics of this machine.
• Keep unauthorized persons well clear of the area of operation.
• Make sure that the machine has been installed in compliance with established legislation and
standards.
• Make sure that all machine operators are suitably trained, that they are capable of using the
machine correctly and that they are adequately supervised during their work.
WARNING
WARNING

SAFETY REGULATIONS

WARNING
11