Switching On; Stand-By Mode; Date And Time Settings - Royal Catering RC-611 E Manual De Usuario

2.3 Switching on

The oven is equipped with an "ON/OFF" button to electrically power the electronic control board and
activate its operational functionality (Fig. 1a).
The button (A) is not directly visible as it is located under the base of the oven, in the direction of the door
sensor: an identification plate (B) on the side indicates its presence.
To activate the oven function, set the button to "ON".
For the first 10 seconds the display shows the "computer codes" of the electronics controlling the oven,
then the following are highlighted (in blue): the "Date and Time", and the symbol (nr.11 Fig.2).
Touching the symbol lights up (in white) the "symbols" and "digits" of the operating parameters
(Fig.1).
B
A
Fig. 1a
.

2.4 STAND-BY mode

If the oven is not being used (it is not performing any operating functions), an acoustic warning ("beep") is
emitted after 10 minutes and the "STAND-BY" mode is activated automatically. In this configuration the
following are highlighted on the display (in blue): the "Date and Time", and the symbol.
After a further 10 minutes without operating functions, only the symbol remains lit up on the display.
To reactivate the oven, touch the symbol, and the "symbols" and "digits" of the operating parameters
related to "start-up" will light up again on the display (Fig. 1).
If the oven is not being used, the "STAND-BY" mode can be activated at any time by tapping on
the
symbol for a few seconds.

2.5 DATE and TIME settings

These settings can only be made in "STAND-BY" mode.
On the display, tap on the digits relating to "Date and Time" (nr.30 Fig.2). The bottom of the
display shows the .
symbols, while the upper part of the display shows the first 2 "digits"
related to the Time value, which are set to be modified by touching the symbols and . Touching the
and the next value to be changed appears automatically.
symbol confirms the set value
Proceed as shown below to set the desired values relating to: "Minutes" - "Day" - "Month" -
"Year".
To exit the setting mode, touch the digits relating to "Date and Time", and the display returns to
"STAND-BY" mode.
To activate the oven, touch the symbol,
8