Technical Support; Disposal Of The Appliance - Royal Catering RC-611 E Manual De Usuario

E15
The glass is up
(In
orange)
E16
The glass is down
(In red)
E18
Blackout
(In red)
E20
Micro power board
not detected
(In red)

7. TECHNICAL SUPPORT

Before leaving the factory this appliance has been calibrated and tested by experienced and skilled
personnel in order to obtain the best operating results. Any repair or calibration must be carried out with
the utmost care and attention, using only original parts.
That is why it is always necessary to contact the Dealer who sold the appliance or our nearest Technical
Support Centre, specifying the kind of failure and what model you have.

8. DISPOSAL OF THE APPLIANCE

In accordance with Directive 2012/19/EU on the disposal of waste electrical and
electronic equipment, the crossed-out wheeled bin symbol on the equipment indicates
that the product was placed on the market after 13 August 2015, and that at the end
of its services life it must be disposed of separately from other waste.
At the end of the appliance's service life, the user must, therefore, deliver it to the
appropriate centres (recycling centres) for the separate collection of electrical and
electronic waste.
All appliances are made of recyclable metal materials (stainless steel, galvanised sheet
metal, iron, copper, aluminium, etc.) which make up more than 90% of the total
weight of the appliance. Before disposing of the appliance, it is recommended to
make it unusable by removing the power supply cable and removing the mechanism
for closing compartments and/or openings, if any.
The separate waste collection and subsequent treatment, recovery and disposal, are conducive to the
production of equipment with recycled materials and reduce the negative effects on the environment and
health possibly caused by incorrect waste handling. Illegal disposal of the product by the user entails the
application of administrative penalties.
Incorrect position of the
glass
Incorrect position of the
glass
Mains power supply
outage for over
minute
The display board does not
communicate with
micro power board
Oven operation
deactivated
Oven operation
deactivated
Oven operation
disabled. When the
power supply
one restored, the display
shows the screen of
the cooking program
currently running
Upgrade the board
the
firmware
Push the glass down
Push the glass up
is
Reactivate the
cooking program
Contact a skilled
technician
14