Usage In Accordance With Instructions - Bosch EPS 118 Manual Original

2. Important notes
Before start up, connecting and operating
Bosch products it is absolutely essential
that the operating instructions/owner's
manual and, in particular, the safety in-
structions are studied carefully. By doing so you can
eliminate any uncertainties in handling Bosch products
and thus associated safety risks upfront; something
which is in the interests of your own safety and will
ultimately help avoid damage to the device. When a
Bosch product is handed over to another person, not
only the operating instructions but also the safety
instructions and information on its designated use must
be handed over to the person.
2.1

Usage in accordance with instructions

The EPS 118, accessories and supplementary equip-
ment sets are intended solely for the testing of passen-
ger injectors with solenoid valve (CRI) and passenger
injectors with piezo valve (CRI Piezo) and commercial
Injectors (CRIN). The accessories and supplementary
equipment sets listed, as well as all replacement and
wearing parts are only to be used in conjunction with
products from Robert Bosch GmbH. Any other use
above and beyond this is considered not for the in-
tended purpose. The manufacturer/supplier will not be
liable for any damage resulting from such use. The user
bears the sole risk.
Principle
¶
Operating instructions and safety instructions must
be kept close to hand at the service location.
¶
All safety instructions and hazard information on the
products are to be observed and kept in a legible
condition.
¶
Rectify any faults immediately which may impair safety!
¶
In the event of any safety-relevant modifications to
the product shut down the product and notify the
department/person in charge immediately.
¶
In the event of any modifications to the product's
operating characteristics, shut down the product
and notify the department/person in charge imme-
diately.
¶
Operate all products and the accessories required for
testing within their specified operating ranges only.
Robert Bosch GmbH
Important notes | EPS 118 | 47
¶
The test sample should only be tested with the test
equipment specified by the manufacturer. Adhere to
safety instructions of respective manufacturer for all
test equipment, which does not originate from the
automotive aftermarket. Failure to do so can lead to
danger for the operator and the test sample.
¶
The product must be secured when not in use by
disconnecting the EPS 118 from the AC network.
¶
Adhere to prescribed or operating-instruction specif-
ic periods for recurring tests/inspections.
¶
Perform inspection service to safeguard adjusting
accuracy every 2 years (e.g. according to ISO 9000).
en
|
1 689 989 220 2016-02-05