Preparation Of Inlet Connector (Special Accessories); Setting The Language - Bosch EPS 118 Manual Original

en 66 | EPS 118 | Commissioning
6.6 Preparation of inlet connector
(special accessories)
1
458852-02_Pal
Fig. 25: Preparation of inlet connector
1 Inlet connector (1 683 386 166)
2 O-ring 9.5 x 2 (1 680 210 143)
¶
Slip the O-ring 9.5 x 2 (fig. 25, item 2) over the inlet
connector (fig. 25, item 1).
|
1 689 989 220 2016-02-05
6.7
i
Note the key to symbols in sec. 7.9.1.
6.7.1
After the EPS 118 software has been launched, the lan-
guage must be set (English is preset at the factory).
2
1. Use the mains switch to switch on the EPS 118 (fig. 2,
item 1).
 The EPS 118 starts. If the screen is not activa-
ted, press and hold the computer on/off switch
(fig. 1, item 3) until the computer vendor logo is
shown.
i
If a locked screen with a lock appears, move the lock
in the desired direction to unlock.
2. Select <Guest>.
 The EPS 118 software starts up (standard langu-
age is English).
 The start screen appears.
3. In the start screen, select the menu "Options >>
Settings >> Locale Settings".
4. Select the desired language (German).
5. Save the settings, and exit with <Back>.
"
This completes language setting.
Settings

Setting the language

Robert Bosch GmbH