Adjusting / Replacing The Stick Tops; Plastic Stick Top With Three Buttons: Installation And Functions - Multiplex ROYALpro 7 Manual De Instrucciones

Fig. 9.4.7.1.
a. Using the T6 TORX screwdriver (located in clips in
the transmitter back cover) (
loosen the three TORX screws which retain the
appropriate stick unit until the unit can be swivelled.
b. Rotate the stick unit to the angle which seems
most natural to you (
the TORX screws again. Don't over-tighten them,
or you might strip the threads in the plastic.
1
3
2
Fig. 9.4.7.2.
9.4.8.

Adjusting / replacing the stick tops

pro
The ROYAL is supplied as standard with three
pairs of stick tops of different lengths. They are easily
changed, rotated and adjusted in length:
a. Place the transmitter on a flat surface.
b. Hold the stick top in one hand, and loosen the
locking nut by turning it clockwise with your other
hand ( Fig. 9.4.8.1.).
The stick shaft is smooth, so the stick top can now be
rotated or adjusted in length. If you wish to change the
stick tops, unscrew the locking nuts and use them to
secure the alternative items (
Before fitting the stick tops please ensure that the
shafts are clean and devoid of grease or oil. If you ne-
glect this, the stick tops may not stay in position.
Fig. 9.4.8.1.
Fig. 9.4.7.2.),
Fig. 9.4.7.3.), then tighten
Fig. 9.4.7.3.
Fig. 9.4.8.2.).
Fig. 9.4.8.2.
9.5. Plastic stick top with three but-
tons: installation and functions
If your model features important supplementary func-
tions, the long stick top with push-button / switch
(# 7 5303, supplied with the transmitter) may be use-
ful, as it provides a fast, simple and reliable method of
operating such functions without having to let go of
the stick.
Fig. 9.5.1.
The top button KTa has a momentary function.
The two side-mounted buttons to-
gether form the switch KSw.
This stick top is connected to the
transmitter electronics by means
of two wires. The button and the
switched function can be assigned
to transmitter controls
switches using the same pro-
cedure as for the other buttons (H
and M) and switches.
Fitting this stick top is quick and simple, and requires
no soldering:
a. Switch the transmitter OFF and remove the stick
top.
b. Locate the two connecting wires attached to the
stick top with the push-buttons, slip them through
the locking nut and the stick shaft (
then install the stick top exactly as described in
Chapter 9.4.8.
Tip:
You will find it easier to thread the wires through
the stick shaft if you curve the cable ends slightly
and hold the stick in one corner position.
c. Clip the wires from the stick unit in the holders de-
signed for them. Check that the cables have plenty
of 'elbow room' when you move the stick, are
never under tension, i.e. they cannot become
trapped at any position of the associated stick.
d. Locate the appropriate screw clamp terminal block
on the main circuit board, and run the bare wire
ends to the clamps (
screwdriver required) from the transmitter battery
side; you will need to remove the battery before
doing this. The two wires can be connected to ter-
minals C and D either way round.
Manual
Fig. 9.5.2.
KSw '
KSw #
and
Fig. 9.5.3.
Fig. 9.5.4.),
Fig. 9.5.5; small slot-head
19