Multiplex ROYALpro 7 Manual De Instrucciones página 429

V-TAIL+
Elevator
*
Rudder
Spoiler
Flap
Thr -Tr
* only appears if V-TAIL+ is active
trv' = Control surface deflection
for down-elevator
trv# = Control surface deflection
for up-elevator
trv' = Control surface deflection
for rudder in one direction
(e.g. up)
trv# = Control surface deflection
for rudder in the other di-
rection (e.g. down)
Elevator trim correction for Spoiler
(airbrakes):
pt1 = Elevator compensation for
half-deployed spoilers
pt2 = Elevator compensation for
fully deployed spoilers
Elevator trim correction for Flap:
trv' = Elevator compensation for
(e.g.) Thermal setting
trv# = Elevator compensation for
(e.g.) Speed setting
Elevator trim correction for throttle
(motor):
dead = Dead-zone / from which
point does elevator cor-
rection take effect?
trv = Elevator compensation for
full-throttle
HOTLINER model template
21.1.3.
Suitable for:
F5B.
Typical models:
BLIZZARD (V-tail required (
Akro, Akro Star.
Assigned transmitter controls and switches:
POWER
Assignment used:
Not used: Combi-Switch (N),
Spoiler (E), Flap (F).
You will find an overview of the global assignment of
transmitter controls and switches in Chapter (
Assigned servos / receiver outputs:
1
AILERON+
2
ELEVATR+
Servo configuration MPX-UNI
Timer setting: Motor run time
´
Sum timer controlled by Throttle (
Fine-tuning:
!
Steps a. and b. (
Check functions.
c. Ailerons raised as landing aid
This function is already programmed in the tem-
plate (all mixer inputs = 0% ) and is operated using
the transmitter control Spoiler (slider E). You
may need to add the trim correction input ( 15% ) to
the ELEVATR+ mixer.
d. Activate throttle to elevator mixer
G, select ELEVATR+ , select Thr -Tr input,
set 10% down-elevator.
If you wish to adjust the value in flight, allocate it to
one of the 3-D digi-adjusters (
Manual
21.1.)), Bonito,
22.1.).
4
Throttle
5
AILERON+
‡
).
21.1.),
20.1.).
97