Parameter Throttle Min. (Idle, Throttle Limiter); Main Menu £Mixer; Menu Mixer; Fixed-Wing Models - Multiplex ROYALpro 7 Manual De Instrucciones

or motor OFF in the case of an electric power sys-
tem). The auto-rotation flight phase is primarily used
for practising auto-rotation landings.
Points P1 ... P5 cannot be set separately, i.e. chang-
ing any one value also changes all the other points.
The fixed throttle value for auto-rotation is reduced or
increased:
Note:
At any one time the screen can only display the throttle
curve for the active flight phase. If you wish to change
the throttle curve, please remember that you must first
activate the appropriate flight phase before you actu-
ally alter the value.
15.4.12. Parameter Throttle Min. (idle, throttle
limiter)
The parameter Min. defines the idle speed of the
power system when the throttle limiter is at minimum
or idle. If your model is powered by a glow engine, this
is the speed which is required for starting the engine
and maintaining a safe idle (approx. 20% ). For electric-
powered models the setting should be 0% (= motor
OFF). This parameter applies to all flight phases, and
can be adjusted if necessary using the idle trim (trim
buttons for the collective pitch stick) ( ).
The horizontal dotted line in the graph shows the posi-
tion of the throttle limiter in all flight phases. The throt-
tle limiter restricts the throttle setting.
Tip:
If you wish to adjust the idle (parameter Min. ), first
move the throttle limiter to the idle position. The
change in the Idle setting Min. can then be seen di-
rectly from the horizontal dotted line which indicates
the throttle limiter:
Main menu £Mixer
16.
The main menu Mixer is opened by pressing this but-
ton:
The menu is dynamic, i.e.:
The menu content is different for fixed-wing mod-
els and model helicopters.
Only those mixers are displayed to which at least
one servo has been assigned.
Certain mixers are always present for fixed-wing
model aircraft and model helicopters (
16.2.).
!
Gyros in fixed-wing model aircraft:
If you have assigned the gyro function to a servo, then
Gyro also appears in this menu. You will find a descrip-
tion of this function in Section (

Menu Mixer

16.1.
Mixers which are always present:
Three mixers are always present in the Mixer menu,
regardless of the servo assignments. You will find
them at the start of the dynamic section with the free
mixers:
£Mixer
¨Exit
Combi-Sw.
Ail.Diff
Control Mix

Combi-Sw. (Combi-Switch)

16.1.1.
Separately variable for each flight phase, switch is de-
fined under CS/DTC in the menu: ¡Assignment ,
Switches :
£Combi-Sw..NORMAL
¨Exit
Combi-Sw. <N
Ail < rudder– OFF
In our example the Combi-Sw. menu shows the
switch used ( <N on the left side of the transmitter), the
direction for "ON" ( # = back) and the current position
( * = ON).
Adjustment range:
-200% OFF
Ail < rudder
Default
Increment: 2%
!
Flight phase specific!
Manual
16.1. and
16.2.2.).

Fixed-wing models

....
....
....
#*
200%
Ail. > rudder
71