Multiplex ROYALpro 7 Manual De Instrucciones página 431

DELTA model template
21.1.4.
Suitable for:
Deltas / flying wings, powered or unpowered, jets.
Typical models:
TWIN-JET, FunJet, TWISTER.
Assigned transmitter controls and switches:
Assignment used: POWER
Not used: Combi-Switch (N),
Spoiler (E), Flap (F)
You will find an overview of the global assignment of
transmitter controls and switches in Chapter (
Assigned servos / receiver outputs:
1
DELTA+
4
Throttle
Servo configuration MPX-UNI
Timer setting: Motor run time
´
Sum timer controlled by Throttle (
Fine-tuning:
!
Steps a. and b. (
Check functions.
c. Using receivers with fewer than five channels
Change servo assignment: K Servo , Assign-
ment :
e.g. 1 DELTA+ , 2 DELTA+ , 3 Throttle .
d. Control surface travels too large or too small
G , select DELTA+ mixer, adjust Elevator and / or
Aileron inputs.
e. Activate throttle to elevator mixer
G, select DELTA+ , select Thr -Tr input,
set 10% down-elevator.
If you wish to adjust the value in flight, allocate it to
one of the 3-D digi-adjusters (
22.1.).
5
DELTA+
‡
).
21.1.),
20.1.).
Mixers:
Mixer Input Note
Mixer: Combi-Switch
Combi Sw.
Aileron differential
Ail.Diff.
Mixer: Controls Mix
Controls
Mix
Setting for maximum deflection of the
elevons (opposite directions) when the
transmitter control Aileron is moved:
trv =
DELTA+ Aileron
If you require differential aileron travel,
use Ail.Diff.
trv' = Elevon travel for down-elevator
Elevator
trv# = Elevon travel for up-elevator
Elevator trim correction for throttle (mo-
tor):
dead. = Dead-zone / from which
Thr. -Tr
Manual
12.11.2.
12.6.
16.1.3.
Symmetrical travels
(Same aileron travels up and
down)
point does elevator
correction take effect?
trv = Elevator compensation for full-
throttle
99