Main Menu: ¢Control - Multiplex ROYALpro 7 Manual De Instrucciones

pro
ROYAL
Extra switch connections switch or push-button
This also determines the name by which the switch is
addressed in the transmitter software. The Extra
Switch can be used as a transmitter control (e.g. re-
tract switch, spoilers, ...) or as a simple switch (e.g.
flight phases, ...).
!
The Extra Switch has priority!
The Extra Switch has priority over the physical con-
trols P, K and the stick switch KSw (
trol element installed in the transmitter for the Extra
Switch can be left in the transmitter, but the software
ignores it.
Example: 2-position switch for retracts
Once the switch is installed and connected to the ABC
terminals, the procedure is as follows:
1. Assigning the Extra switch
Main menu: ¡Setup
Assignment
Menu:
Sub-menu: Switches
Parameter: Extra Sw.
Open by pressing ENTER, confirm the warning
message, then select KSw. :
Extra Sw. ->
Confirm with ENTER.
2. Assigning a control for retracts (landing gear)
Main menu: ¡Setup
Assignment
Menu:
Sub-menu: Controls (not Switches !)
Parameter: L. gear
Open by pressing ENTER, confirm the warning
message, then move the stick switch
(Quick-Select):
L. gear KSw
and confirm with ENTER.
92
3 2
2
1
1
9.5.). The con-
KSw
#*
3. Assigning a servo for retracts (landing gear)
Main menu: ¤Servo
Assignment
Menu:
Select desired servo (e.g. Servo 9 ), open by press-
ing ENTER:
9 L. gear UNI
then confirm with ENTER.
Select UNI or MPX as signal format,
confirm with ENTER.
Select 2P , as only the two end-points are of inter-
est for servo travel settings,
confirm with ENTER.
4. Reversing the servo and adjusting the
end-points
Main menu: ¤Servo
Calibrate
Menu:
Sub-menu: 9 L. gear
Parameter: á (to reverse)
P1 and P5 (end-points).
5. Set the transit time if required
Main menu: ¢Control
L. gear
Menu:
Parameter: T ime
Time — 4.5s
maximum setting 6.0 seconds.
e. Using the second stick button
If one stick button is already installed, the second
must be connected to the terminal clamps BC.
The button connected at this point must be allocated
as Extra Sw. K> or <P in the software before it can
be assigned as a control or switch.
Tip:
Assign it to <P if the button is in the left-hand stick,
and K> if it is in the right-hand stick.
Main menu: ¡Setup
Assignment
Menu:
Menu point: Switches
Parameter: Extra Sw.
Extra Sw. ->
!
The assignment for Extra Sw. applies to all
the assignment lists. Any switch installed at K or
P and connected to the corner unit is disabled
once you have assigned the Extra Sw.
2P
K>