Menu: Modulation; Special Facilities; Using The 3-D Digi-Adjuster To Alter Settings In Flight - Multiplex ROYALpro 7 Manual De Instrucciones

pro
ROYAL
The Assignment determines which of the possible
assignment lists for transmitter controls and switches
is to be used for this model. This setting can be
changed subsequently.
f. OK
Once you have set all the parameters described
above, you must click on the OK field by pressing
the ENTER button or one of the 3-D digi-adjusters
to conclude the set-up procedure for the new model.
The memory now switches automatically to the model
you have just created, and you can immediately start
fine-tuning the settings.

Menu: Modulation

19.7.
In this menu you can activate the new MULTIPLEX
M-PCM encoding process.
If you activate this encoding process, it is also possi-
ble to set the Fail-Safe positions for all servos to-
gether.
!
Note:
Any change to the modulation only applies to the cur-
rent model memory.
¦Modulation
¨Exit
M-PCM
set failsafe
a. Activating M-PCM
If you select this menu point and then change the
ON
setting to , then the control signal will be en-
coded using the M-PCM process.
Switching M-PCM to
the PPM encoding method, which works with all
makes of equipment.
b. Setting Fail-Safe ( set failsafe )
Requirement:
- M-PCM must be active.
- The model must be switched on, and under
control from the transmitter.
At this menu point you can set the fail-safe posi-
tions for the individual servos in the model from the
transmitter:
Open the menu point
Move the transmitter controls to the positions
which are to be stored as the fail-safe settings.
If you now press the REV/CLR button, the data is
transferred to the receiver. The screen display
ON
changes briefly to
mission is complete, the marker jumps back to
OFF
.
Press the ENTER button to quit this menu point.
The marker now jumps back to
88
OFF
OFF
OFF
sets the transmitter to
OFF
.
(< 1 sec). When the trans-
set failsafe
20.

Special facilities

20.1. Using the 3-D digi-adjuster to alter
settings in flight
Many model settings can only be optimised when the
model is in the air. A typical example of this is aileron
differential, or Expo settings.
Each of the two 3-D digi-adjusters can be assigned
any of the parameters which are marked in the menus
with a small hyphen " - ".
F
Button is used to unlock / lock the allocated values
for alteration:
Example - aileron differential:
1. Select the parameter Aileron differential
Select the menu £Mixer , Ail.Diff. and press
ENTER to confirm. Select Diff . and confirm again
with ENTER:
2. Press the Accept button
The 3-D digi-adjuster symbol now appears on the
screen instead of the percentage value (%) for the
parameter:
Now press one of the 3-D digi-adjusters to select
the one (left or right) which you wish to use to al-
ter the value in flight.
3. You can now leave the menu and return to the
Status display.
The top line in Status displays 1 - 3 now shows
that aileron differential Ail.Diff. can be ad-
justed using the right-hand 3-D digi-adjuster:
If you now press or rotate the appropriate 3-D digi-
adjuster, the current set-up value for the parameter
appears on the screen for a moment:
.
F