Boston Scientific MAESTRO 4000 Manual De Instrucciones página 12

RF Generator Rear Panel
This section describes the connections and controls on the rear panel of the cardiac RF Generator shown in
Figure 2.
Mains
VA POWER INPUT
Power
Hz FREQUENCY
AC VOLTAGE
W
Inlet
kHz
Made In USA:
560 Cottonwood Drive
Milpitas, CA 95035
USA
C
871-0186-000 REV A
Mains Power Inlet
The Mains Power Inlet connects to an AC wall outlet designated as "Hospital Grade" or "Hospital Only"
using a "Hospital Grade" power cord.
Potential Equalization Terminal
• This terminal can be used to verify compliance with 60601-1.
• This terminal is used for connecting dedicated ground leads.
Foot Switch Connector
This connector is used for the optional Foot Switch.
Peristaltic Pump Connector
This connector can be used to communicate with the optional MetriQ™ Pump.
Remote Connector
This connector can be used to communicate with the optional Remote.
EP Recording System Connector
This connector allows the RF Generator to communicate the ablation parameters to the EP Recording
System.
Speaker Volume Knob
This knob adjusts the volume of the RF Generator audio speaker.
12
Black (K) ∆E ≤5.0
EP Recording System Connector
Peristaltic
Remote
Pump Connector Connector
Peristaltic
Pump
300 VA
50/60 Hz
100-120 / 220-240V
RATED OUTPUT POWER 50, 100, 150
RATED LOAD 100
OPERATING FREQUENCY 460
cTUVus Mark indicates compliance to
Separate
UL 60601-1 and CAN/CSA 22.2 601.1 M90
Collection
covering electrical safety requirements
for the US and Canada.
US
90818618-01A
Equipotentiality Terminal
Figure 2. RF Generator Rear Panel
Foot Switch Cable Connector
Maestro 4000™ Controller
RF Cardiac Ablation Controller
M00440000
4000
Catalog No.
REF
Date of YYYY-MM-DD
Manufacture
12345678
Serial Number
SN
Follow Instructions
For Use
Maestro 4000™ Cardiac Ablation System Operator's Manual, Global
Speaker
Volume