Ejemplo De Subrutina - Fagor Quercus CNC 8060 Manual De Instalación

16.5.2
16.
Quercus
CNC 8060
CNC 8065
R : 2010
EF
ꞏ624ꞏ

Ejemplo de subrutina.

Ejemplo de subrutina Sub_Probe_Piece_Begin.fst suministrada por Fagor (a adaptar
por el OEM).
#ESBLK
; Activate PROBE 2 Hardware by PLC output.
; Check PROBE is READY with PLC Input from Probe Hardware.
#MSG["WAIT FOR ENABLING PROBE2"]
#WAIT FOR[V.PLC.PROBE2ENA==1]
#MSG[""]
; Select PROBE 2 input for using in Probing.
#SELECT PROBE[2]
#FLUSH
$IF [V.G.PRBST2==1]
#WARNING["PROBE2 SIGNAL TOUCHING"]
M0
$ENDIF
; Check probe in safe mode feature is actived.
$IF [V.PLC.PROBE2MONIT==0]
#MSG["PROBE NOT IN SAFE MODE"]
$ENDIF
#RETDSBLK
#COMMENT BEGIN
PLC signals to add in the logic:
PROBE2ENA; PROBE 2 is enabled confirmation signal to CNC.
If not used in PLC, it is actived by default.
PROBE2MONIT; It activates PROBE2 in SAFE mode.
If probe is actived in no G100/G103 motion, CNC will stop motion and shows an error.
If not used in PLC, it is actived by default.
#COMMENT END
Ejemplo de subrutina Sub_Probe_Piece_End.fst suministrada por Fagor (a adaptar
por el OEM).
#ESBLK
;Deactivate PROBE2 Hardware by PLC output
#RETDSBLK
M a n u a l d e i n st a l a c i ó n .