Pioneer VREC-130RS Manual Del Propietário página 14

3 Adjust the installation angle.
Loosen the angle adjustment nut to adjust. After adjusting, tighten the loosened nut to secure.
Angle
adjustment nut
4 Connect the cigarette lighter power cable to the vehicle accessory socket.
Route the power cable to the passenger seat side. Fully insert this into the vehicle accessory socket
to make a good connection. (The location of the accessory socket will differ depending on the
vehicle.)
CAUTION
• The accessory socket will be extremely hot immediately after using the cigarette lighter. The tip of the
cigarette lighter power cable may melt or short circuit if it is plugged in while the socket is hot. Wait
for the socket to cool before plugging in the cigarette lighter power cab
5 Turn the vehicle engine on to display the recording screen.
Note
A protective film is applied to the lens when the product is purchased. Peel off this film.
6 Installing the Safety Strap.
① Hook the smaller loop of the safety strap around the Mounting Cradle where it connects to the
Main Unit, and then connect the Mounting Cradle to the Main Unit.
② Hook the larger loop of the Safety Strap around the Rear View mirror attached to the windscreen.
③ Once the Safety Strap is connected to both the Rear View Mirror and the Dash Camera, attach
the Dash Camera to the front windscreen close to the location of the Rear View Mirror.
Note
Always install this Safety Strap as described. Do not cut the Safety Strap or install it in any other way
than as described. Pioneer is not liable for any damage, due to installation other than described, or
use of the product.
7 Removing this product
① Unhook the mounting cradle from the windscreen.
② Remove this product.
− 14 −