To Prevent Damage - Pioneer VREC-130RS Manual Del Propietário

Precautions before connecting the system
CAUTION
• Firmly install this product so it does not fall off the windscreen. If this product is not firmly installed,
it may fall off the windscreen while driving and cause an accident. Periodically inspect this product.
• Secure all wiring with cable clamps or electrical tape. Do not allow any bare wiring to remain exposed.
• It is extremely dangerous to allow cables to become wound around the steering column or gearstick. Be sure
to install this product, its cables, and wiring away in such so that they will not obstruct or hinder driving.
• Make sure that the cables and wires will not interfere with or become caught in any of the vehicle's
moving parts, especially the steering wheel, gearstick, handbrake, sliding seat tracks, doors, or any
of the vehicle's controls.
• Do not route wires where they will be exposed to high temperatures. If the insulation heats up, wires
may become damaged, resulting in a short circuit or malfunction and permanent damage to the
product.
• Do not shorten any cables. If you do, the protection circuit (fuse holder, fuse resistor or filter, etc.) may
fail to work properly.
• Never feed power to other electronic products by cutting the insulation of the power supply cable of
this product and tapping into the cable. The current capacity of the cable will be exceeded, causing
overheating.

To prevent damage

WARNING
• When replacing the fuse, be sure to only use a fuse of the rating prescribed on this product.
Precautions before installation
CAUTION
Never install this product in places where, or in a manner that:
• Could injure the driver or passengers if the vehicle stops suddenly.
• May interfere with the driver's operation of the vehicle, such as on the floor in front of the driver's seat,
or close to the steering wheel or gearstick.
• To ensure proper installation, be sure to use the supplied parts in the manner specified. If any parts
are not supplied with this product, use compatible parts in the manner specified after you have the
parts' compatibility checked by your dealer. If parts other than supplied or compatible ones are used,
they may damage internal parts of this product or they may work loose and the product may become
detached.
• Do not install this product where it may
(i) obstruct the driver's vision,
(ii) impair the performance of any of the vehicle's operating systems or safety features, including
airbags, hazard lamp buttons or
(iii) impair the driver's ability to safely operate the vehicle.
• Never install this product in front of or next to the place in the dashboard, door, or pillar from which
one of your vehicle's airbags would deploy. Please refer to your vehicle's owner's manual for reference
to the deployment area of the frontal airbags.
• Consult with your nearest dealer if installation requires drilling holes or other modifications of the
vehicle.
• Before making a final installation of this product, temporarily connect the wiring to confirm that the
connections are correct and the system works properly.
• Do not install this product in places subject to high temperatures or humidity, such as:
— Places close to a heater, vent or air conditioner.
— Places that may be exposed to rain, such as close to the door or on the vehicle's floor.
− 5 −